Memmert AtmoCONTROL - Manual (Page 13)

D24042 | Date 09/2014 13
AtmoCONTROL
4. Programme
4.1 Editor window
4.1.1 Overview
In the Editor window, programmes can be created: sequences of various parameters (e.g.
temperature, pressure and humidity), which the appliance then implements from a definable
point in time.
To be able to create a programme in AtmoCONTROL, the appliance which is to perform the
programme must be listed in the status bar and selected (clicked on). The appliance can, but
does not have to, be connected to the computer via the network. If the appliance is not yet
listed in the status bar, it must be added (see page 10).
4.1.2 Creating a programme
Select the appliance that will later perform the programme by clicking on it in the status
bar (Fig. 2, No. 1). An icon bar with the available parameters (functions) for this appliance is
shown (2, description from page 16). Additionally, one or two editor threads (3 and 4) are
displayed, depending on the appliance. The programme sequence is determined on these.
Two editor threads are always shown for appliances with humidity or pressure control,
and one editor thread for all others.
Bear in mind that the two editor threads are not synchronised. This means that a specific X
position on one thread does not match the same position on the other thread in time. If you
want to see the parameter values for a specific point in time, you must change to the simula-
tion mode (see page 22).
If you want to create a time correlation to a specific point, use the "Sync" function (see page
20).
1
2
3
4
 
 
 
Elements to create a programme
1 Appliance selected
Fig. 2 Fig. 2 Elements to create a programme Elements to create a programme
2 Available parameters (functions)
Appliance selected Appliance selected
3 Editor thread
Available parameters (functions) Available parameters (functions)
4 Additional editor thread for appliances with humidity or pressure control