Brother DCP-110C - Manual (Page 41)

GETTING STARTED 2 - 6
Setting the Beeper Volume
You can change the beeper volume. The default (factory) setting is
Low . When the beeper is on, the machine will beep when you press
a key, make a mistake or after you send or receive a fax.
1
Press Menu/Set , 1 , 4 , 2 .
2
Press ▲ or ▼ to select your option.
( Low , Med , High or Off )
Press Menu/Set .
3
Press Stop/Exit .
Setting the Speaker Volume
You can adjust the speaker volume.
1
Press Menu/Set , 1 , 4 , 3 .
2
Press ▲ or ▼ to select Low , Med , High or Off .
Press Menu/Set .
3
Press Stop/Exit .
—OR—
In Fax mode , you can adjust the speaker volume by pressing
Speaker Phone , and then selecting a speaker volume level.
Press or to adjust the volume level. The LCD shows the
setting you are choosing. Each key press changes the volume to the
next setting. The new setting will remain until you change it again.
■
You can adjust the speaker volume while you are listening to
your OGM (Outgoing Message) and ICMs (Incoming
Messages).
■
If you turn Incoming Recording Monitor to OFF ( Menu/Set ,
2 , 7 , 3 ) the Speaker for screening calls will be disabled and
you won’t hear callers leaving messages. The volume for
other operations can still be controlled using
or .