Marshalltown 1220MP Mortar/Plaster Mixer - Manual (Page 9)

9 of 44
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
WS1169
6-2014/Rev.A
ASSEMBLY
TOW POLE
The tow pole assembly is located on the front of the mixer and is used for transport only. For transport, pull the tow pole
assembly out, line up the holes and insert the L-shaped pin through each hole. While operating the mixer, pull the L-shaped
pin out of the hole and push tow pole assembly all the way in. Line up the holes and insert the L-shaped pin through each
hole.
ELECTRIC MOTORS
Electric Motors on MP mixers are sold WITHOUT a power cord because of the variety of voltage/plug configurations
available. Most electrical supply stores can provide the correct wiring harness and plug for any application.
HYDRAULIC PUMPS
No hydraulic assembly required. The speed of the mixing shaft can be adjusted using the flow control inside the engine
house.
GREASING
All mixers are greased before their factory test, but each unit should be greased prior to its first use (see lubrication section
on page
12). This will replace any grease that was lost or contaminated during transport.
DRUM WIPER BLADES
The mixing paddles feature adjustable rubber wipers and steel backing plates. Wipers are factory preset to lightly contact
the inside of the drum.
Model
Batch
Volume
Cu. Ft.
Total Drum
Volume
Cu. Ft.
Batch
Cap. Bags
Bearing/Seal
Clutch
Mechanism
Power Reduction
800MP 8 9.8 2 Roller Bearings w/Stacked Seals Pivoting Engine Mount
6:1 Reduction;
Belt to Chain & Sprocket
1200MP 12 14.1 4 Roller Bearings w/Stacked Seals Pivoting Engine Mount
6:1 Reduction;
Belt to Chain & Sprocket
1220MP 12 14.1 4 Roller Bearings w/Stacked Seals Hydraulic Hydraulic
1620MP 16 17.4 5 Roller Bearings w/Stacked Seals Hydraulic Hydraulic
Model Tow Pole Wheel & Tire Suspension
Overall
Dimensions
L X W X H
Discharge
Height
Power
Options
800MP 2- 7 / 8 " Dia. Telescoping
6.5" X 13" Wheels
25" O.D. Tires
Torsion Axle 73" X 54" X 59" 24"
3HP Electric
8HP Honda ®
1200MP 2- 7 / 8 " Dia. Telescoping
6.5" X 13" Wheels
25" O.D. Tires
Torsion Axle 80" X 54" X 59" 24”
3HP Electric
8HP Honda ®
1220MP 2- 7 / 8 " Dia. Telescoping
6.5" X 13" Wheels
25" O.D. Tires
Torsion Axle 88" X 54" X 59" 24”
7.5HP Electric
13HP Honda ®
1620MP 2- 7 / 8 " Dia. Telescoping
6.5" X 13" Wheels
25" O.D. Tires
Torsion Axle 96" X 54" X 59" 24”
7.5HP Electric
13HP Honda ®
SPECIFICATIONS