Maintenance schedule, Warning – Marshalltown 1220MP Mortar/Plaster Mixer User Manual
Page 41
41 of 44
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com
WS1169
6-2014/Rev.A
MAINTENANCE SCHEDULE
NOTICE: Record the model and serial numbers in the spaces provided.
Mixer serial numbers can be located on the nameplate
Engine Model, Type and Code numbers are located on the blower housing, cylinder head or backplate
Product Model Number: ______________________________________________
Product Serial Number: _______________________________________________
Engine/Motor Model Number: _________________________________________
Engine/Motor Code Number: __________________________________________
Purchase Date: ______________________________________________________
Dealer Purchased From: ______________________________________________
Dealer Address: ______________________________________________________
____________________________________________________________________
Dealer Phone Number: ________________________________________________
WARNING!
• Keep hands out of the drum at all times when the engine/motor is turning.
• Observe all safety decals. Replace any safety decals that cannot be read.
• Always use guards and safety devices in their intended manner.
• Disconnect spark plug wire or electric cord before cleaning inside the drum.
• Hydraulic fluid may be hot. Allow fluid and equipment to cool before servicing.
ENGINES AND MOTORS:
For information on maintenance of your engine or motor, refer to the information provided by the manufacturer.
WEEKLY MAINTENANCE:
• Grease drum shaft bearings, drum seals, and drum bearing hangers.
• Grease drive shaft bearings.
• Check the tension and condition of the belts. Tighten or replace as necessary.
• If applicable, check all hydraulic hoses and fittings for leaks. Fix any leaks before operation.
MONTHLY MAINTENANCE:
• Check all bearings and seals for damage. Replace as necessary.
YEARLY MAINTENANCE:
• Repack wheel bearings with grease and replace seals.