Lenze PLC Designer Migration PLC Designer (R2-x)-PLC Designer (R3-x) - Manual (Page 3)

Lenze · PLC Designer | Migration of V2.x projects · 1.2 EN - 02/2013
3
About this documentation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
2 About this documentation
This documentation contains information on how to import older »PLC Designer« projects into the
»PLC Designer«.
This manual is assigned to the "Controller-based Automation" manual collection which consists of
the following documentations:
Documentation Subject
System manuals • "Controller-based Automation"
• Visualisation
Communication manuals • "Controller-based Automation" EtherCAT®
• "Controller-based Automation" CANopen®
• "Controller-based Automation" PROFIBUS®
Software manuals (SW) • »PLC Designer«
• »Engineer«
• »VisiWinNET® Smart«
• »Backup & Restore«

Information on how to use the L-force Controller beyond control technology can be
found in the system manuals dealing with the respective application case.