Lenze SMVector RS-485 LECOM - Manual (Page 5)

3 CMVLC401A
Safety Information
1.5 Operation
Systems including controllers must be equipped with additional monitoring and protection devices according to the
corresponding standards (e.g. technical equipment, regulations for prevention of accidents, etc.). You are allowed to
adapt the controller to your application as described in the documentation.
DANGER!
• After the controller has been disconnected from the supply voltage, do not touch the live components
and power connection until the capacitors have discharged. Please observe the corresponding
notes on the controller.
• Do not continuously cycle input power to the controller more than once every three minutes.
• Close all protective covers and doors during operation.
WARNING!
Network control permits automatic starting and stopping of the inverter drive. The system design must
incorporate adequate protection to prevent personnel from accessing moving equipment while power
is applied to the drive system.
Table 1: Pictographs used in these instructions
Pictograph Signal Word Meaning Consequences if Ignored
DANGER! Warning of Hazardous
Electrical Voltage.
Reference to an imminent danger that may
result in death or serious personal injury if
the corresponding measures are not taken.
WARNING! Impending or possible
danger for persons
Death or injury
STOP! Possible damage to
equipment
Damage to drive system or its
surroundings
NOTE Useful tip: If observed, it will
make using the drive easier