Lenze SMVector RS-485 LECOM - Manual (Page 24)

22 CMVLC401A
Commissioning
Code
Number Parameter Name Default Range of Adjustment Important
C0200 Software
Identification Software identification string:
example “33SSSMD-M_14000”
LECOM Format = VS Read only
C0201 Software
Generation Date Software generation date:
example “2008-10-18”
LECOM Format = VS Read only
C1050 Network Controlled
Digital Output
(TB14) + Relay 0 = de-energized
1 = energized
bit 9:
TB-14 state
bit 10: Relay state
other bits are not used
Refer to section 8.1.1
C1055 Network Controlled
Analog Output 0.0% 0.0 … 100.0 Refer to section 8.1.2
C1060 Keypad Speed
Command 20.0 Hz P102 … P103
C1061 Network Speed
Command 0.0 Hz P102 … P103
C1070 Keypad PID
Setpoint Command 0.0 -99.9 … 3100.0 Read only
C1071 Network PID
Setpoint Command 0.0 -99.9 … 3100.0 Read-only
C1072 Actual PID setpoint 0.0 -99.9 … 3100.0 Read only
C1073 PID Setpoint
Command 0.0 -99.9 … 3100.0 Read only
C1074 PID Feedback 0.0 -99.9 … 3100.0 Read only
C1080 Keypad Torque
Command 100% 0.0 … 400.0
C1081 Network Torque
Command 0% 0.0 … 400.0
C1099 Parameter Version Refer to section 8.1.3
8.1.1 C1050 (Network Controlled Digital Output)
To control the state of the relay or digital output (TB14), Drive Programming Parameter P140 and/or P142 must be set
to 25 (Network Controlled).
8.1.2 C1055 (Network Controlled Analog Output)
To control the state of the analog output (TB30), Drive Programming Parameter P150 must be set to 09 (Network
Controlled).
8.1.3 C1099 (Parameter Version)
The Parameter Version identifies the parameter set for the current version of software. If the Parameter version is
different between two drives, it could indicate that a register has been added or deleted, a register’s min/max limits
have changed, a register’s function has been changed, or a register’s default value has been changed.