Leica Biosystems ST5010 Autostainer XL - Manual (Page 25)

25 Leica AutoStainer XL – Automated slide stainer
5.4.4 Removing blank steps in a program
This function is used to remove blank steps where a program has been ed-
ited by deleting one or more steps. Steps will be sequentially renumbered in
the same sequence as the original program.
1. Select the program (see steps 1 and 2, page 22).
2. Press [F2] Edit.
3. Press [F1] More.
4. Press [F1] More.
5. Press [F3] Blank.
6. If you wish to proceed, press [F1] Yes. The blank steps will be removed
and subsequent steps will be renumbered.
7. To save the program, see page 24.
5.4.5 Saving a program
When the program is complete, to save it permanently:
1. From the Edit Program screen, press [F4] Quit. You now have the
options of saving the edited program [F1], leaving the program as it
was before the changes were made [F2], or continuing editing [F4].
2. Press [F1] to save the program, or
3. Press [F2] to leave the program unchanged, or
4. Press [F4] to continue editing the program.
5.4.6 Deleting a program
This function is used to delete all steps in a program.
1. Select the program (see steps 1 and 2, page 22).
2. Press [F2] Edit.
3. Press [F1] More.
4. Press [F1] More.
5. Press [F2] Delete.
6. If you wish to proceed, press [F1] Yes.
7. To save the program (which now contains no steps), see above.
5. Operation