Labnet Prism R Refrigerated Microcentrifuge - Manual (Page 16)

Prism R™ Refrigerated Microcentrifuge 13
5.6. Quick-Spin Operation
The centrifuge can be operated for a short run by pressing and
holding the button. The centrifuge will continue to run as long as
the button is depressed and the time, in seconds, will count up
on the time display. The Quick-Spin speed and temperature is based
on the last run settings remaining in the memory. The icon “RPM” will
flash during Quick-Spin operation.
5.7. Changing the Settings During a Run
Users can change the settings while the rotor is running. Through a
one-time pressing of any function buttons ( , , , ) ,
the current value will switch into the pre-set value mode.
The to-be-changed value flashes, and can then be changed. Once
the display switches into the current value mode after completion of
the entered values, the new values are activated.
The new values are stored and executed by pressing the function
button again or by waiting 6 seconds.
6. Service and Maintenance
Always unplug the power plug before service and maintenance.
6.1. Centrifuge Service
The brushless motor in the Prism R requires no routine maintenance.
Any required service should be performed by authorized, qualified