Kisan Electronics ManualtailBlazer - Manual (Page 26)

Page - 24
INTENSITY ADJUSTMENT:
tailBlazer circuitry utilizes a microprocessor with an e
2
prom to memorize
different settings for the TAIL LIGHT brightness. The BRAKE LIGHT
brightness is always the maximum possible.
The factory setting is for High Intensity. If you find that the contrast
between the tail and brake light brightness is not sufficient, you can adjust
it by programming as follows:
First apply Brakes & HOLD,
then Turn Ignition ON 3 times,
and leave it ON
For European models, the Tail
Light switch must be ON
Brake lamp will flash 3 times
rapidly as a confirmation for
the new setting.
„ The time between each of the Ignition On cycles should not exceed 1.5
seconds.
„ This is a toggle function – you select High from Low Intensity, or Low
from High Intensity.
„ This option is available on Dual Input tailBlazer models only.
„ Once set and confirmed by 3 flashes, the new Setting will remain in
permanent memory of the processor. It is not affected even if the battery
is disconnected or the tailBlazer unit is un-plugged.