Kisan Electronics ManualtailBlazer - Manual (Page 15)

Page - 13
200GW INSTALLATION:
This is a heavy-duty unit
designed to handle up to (4)
brake bulbs. On most
models, access to the brake
wire can be found under the
seat. Please follow the
electrical circuit diagram of
your model and use a
voltmeter to identify the
correct wire and the proper
location to splice-in.
For most multiple bulb type
of taillight arrangements,
there’s typically a connector in the harness before it is split-up to feed
different bulbs.
Once you have identified the brake wire and chosen the correct location
to make the splice, cut and prepare the wire ends as shown here. If you
plan to use the rubber boot, feed
the wires though first by piercing a
small hole at the tip of the boot.
Next, Insert the wire-ends and
screw-in (3) connections as
follows:
„ BRAKE INPUT - is for the stripped wire-end that supplies power.
„ OUTPUT to BULBS - is for the stripped wire-end going to the bulbs.
„ GROUND - is for the wire supplied with ring for attaching to chassis.
Use the Velcro to mount the unit in an appropriate location – away from
high heat or direct water spray.