Kisan Electronics ManualtailBlazer - Manual (Page 23)

Page - 21
Goldwing-1500 INSTALLATION:
25LED is a special unit designed for the GL-1500 SE models with OEM
Spoiler LEDs. It operates with a split voltage supply of 6v/12v. It’s
mounted on the back of the trunk lid with 2-pin plug-in connector.
200GW is also
redesigned with
embedded
microprocessor.
This unit is a (1)
wire splice, and
it mounts under the
seat. To splice-in,
locate the left-side 25-
pin connector under
the seat. The brake wire to splice-in is: Dark Green w/Red Stripe.
Goldwing-1200 INSTALLATION:
100HD is a (1) wire splice-in unit, which is mounted under the seat. The
brake wire is Green w/Red Stripe.
20W-D integrated bulbs are also a suitable application for the older
Goldwings. Simply replace the (2) dual-contact brake bulbs with:
20W-D 2-pak. Refer to the Instructions on following pages for:
„ Programming Tail light Intensity Levels
200GW
25LED
Please Note! If you have a trailer with more than (2) bulbs, it will
exceed the rated wattage. Max Load is (6)x25W or 150W.