100hd-m – Kisan Electronics ManualtailBlazer User Manual
Page 12
Page - 10
100HD-M
tailBlazer
100HD-M has (3) screw-in terminals:
Input Terminal: for Brake Input
Output Terminal: for Output to the bulbs
Ground Terminal: for the Ground
Modulates the Brake bulb for a 4-sec Deceleration Warning
Trigger voltage: 10.9 volts
DO NOT EXCEED THE RATED WATTAGE.
Warranty coverage will be denied, if unit is damaged from overload.
(1) WIRE SPLICE-IN
100HD-M has a modified ballast circuit to allow monitoring voltage
pass-thru. This allows bulb filament detection. If your bike has
dash warning that indicates burned-out brake bulb, this unit is the
correct application. Max load is (3) brake bulbs.