Kisan Electronics CG-10 - Manual (Page 9)

Page - 7
INSTALLATION
COPPER PLATE BENT 90º
Note! Copper plate should only be bent along the two notches. DO NOT pull on
the wires while bending
ZERO SET FEATURE
The Integrated Shunt has been calibrated for zero-
set at the factory. The offset values are stored in
permanent memory of the Display.
If you need to reset null point:
n Turn everything Off – no load on the battery
o Push the Mode button momentarily to show AMP screen
p If the AMP reading is not zero, Push & Hold the button
q Display scrolls through twice & returns to AMP mode. Display
backlight will go dark - now release the Mode button
r Push & Hold the button again. When dashes appear, release
button.
Display will light up and the reading will be set to zero and the new offset
values for the null point you have chosen will overwrite the factory setting.