Kisan Electronics CG-10 - Manual (Page 14)

Page - 12
LED STATUS INDICATOR
g
a
Ungrounded AC outlets, condensation near the outlet or
on the floor, or an overload from another appliance on
the s
t – 3-flashes - chargeX unit must be unplugged from
t
utlet
chargeX onboard
charger LED indicator
shows operating status as
follows:
Continuous flashing – Fast for higher rate and slow for lower
rate of charge. It’s fully automatic.
Solid ON – Charging is completed and optimal battery voltage is
maintained. It will restart as needed to keep optimal voltage.
2-Flashes – indicates a fault in the output connection. It may
be a loose wire or a short-circuited connection. The chargin
function STOPS until the fault is corrected.
3-Fl shes – indicates a fault in the AC input.
ame outlet will cause Ground Fault Interrupt (GFI)
f you see a GFI faul I
the AC outlet for a reset. Before you do that, for your own safety:
„ Make sure that there’s no excessive condensation near the outle
„ Make sure that the outlet is properly grounded and polarized
„ Use a polarized extension cord, if not directly plugging into a wall o
DANGER OF ELECTROCUTION! Unplug this appliance from the
OT touch or step on to any wet surfaces. outlet. DO N