Kisan Electronics CG-10 - Manual (Page 5)

Page - 3
DISPLAY INSTALLATION
f
For best viewing, the Display should be vertical – not lay flat
f
Display location depends on the cable length – to reach the battery
HANDLEBAR MOUNT
X
Choose an
appropriate
location
Y
Determine how
to route both input
cables
Z
Hold the
Mounting Cradle
in place over the
handlebar
[
Use each 1/8” tie wrap supplied, and feed them over the half-round
and the handlebar then pull it tight
\ Make sure the cables have enough slack when you steer both ways.
FLUSH MOUNT
X
Choose an appropriate location
Y
Determine how to route input cables
Z Clean the mounting surface thoroughly
with an alcohol swab
[ Use the mounting tapes supplied
\
Apply pressure to hold it in place