Kargo Master PRO III Ladder Rack for Ford TC (80070) - Manual (Page 7)

S
I
J
Tighten down all nuts & bolts and THAT'S IT! You are now ready to use your rack.
Foot
Foot Flange
Backing Plate
Rubber
Rubber
( inside )
Fiberglass
Camper Shell
DIAGRAM #2
Rubber
Roof Pad
Foot
Inside Roof
Clamp Plate
&
Inside Rubber
Backing Pad
( inside )
STEP 6
STEP 7
#1 = With the rack properly positioned, mark the
TWO outer holes (not the middle hole) on the foot
flange where the through bolts will go through.
See diagram.
#2 = Secure each foot flange, outside rubber
roof pad, inside rubber roof pad, and inside
backing plate using through bolts S,
flat washers I, and lock nuts J. Unless you
have really long arms, this is a two man job.
#1 = CAREFULLY lift each foot one at a
time, remove the tape, and reposition the
rubber roof pad so that the holes are aligned.
NOTE: Be sure that the INSIDE backing plate will be
clear of any obstacles inside the camper shell roof.
#2 = Remove the rack from the roof. CAREFULLY drill
a small pilot hole through the shell. With a 5/16 bit, drill
up from inside, about half way through the fiberglass.
From outside, drill down to finish the hole.
WARNING!
• DRILLING HOLES IN THE CAMPER SHELL ROOF MAY VOID
THE WARRANTY. WE RECOMMEND THAT YOU HAVE AN
AUTHORIZED CAMPER SHELL DEALER DRILL AND MOUNT THE
RACK FOOTPLATES.
**(Camper Shell ONLY)
**(Camper Shell ONLY)
TMCS_3:1