Kargo Master Econo Truck Rack – Without A Camper Shell (30050) User Manual

Econo truck racks assembly instructions, High position ), Low position )

Monday- Friday 8:00 A.M. to 4:30 P.M. (PACIFIC )

ECONO TRUCK RACKS

Assembly Instructions

1-800-343-7486

For TECHNICAL SUPPORT Call:

(2 ea.)

1/2" Lock Washer

(4 ea.)

3/8" Lock Nut

(4 ea.)

3/8" x 3/4"

Button Head

3/8" Flat Washer

(4 ea.)

(2 ea.)

1/2" x 2 1/2"

Button Head Bolt

STEP 7- Secure and TIGHTEN Mount Plate Clip to truck bed rail, and then TIGHTEN down ALL

bolts on the rack.

(4 ea.)

3/8" x 1/2"

Allen Head Set Screw

#30050
#30080

CAB

(2 ea.)

3/8" x 3 1/2"

Tap Bolt

STEP 1-

Position the FRONT MOUNTING PLATES as far forward

towards the cab as possible. Mark and drill a 3/8" hole through the
MOUNT PLATE at the center of the stake pocket.

STEP 2-

Position the T nut in the stake pocket (as shown below).

Depending on the construction of your stake pocket, it may be
easier to loosely attach the tap bolt and T nut to the
MOUNT PLATE before positioning the T nut in the

stake pocket.

STEP 3-

Snug the T nuts and with bolt B and lock washer D , snug the MOUNT

PLATE CLIPS.

IF YOU ARE INSTALLING A CAB GUARD, SLIDE THE TWO CAB GUARD

MOUNT CLIPS OVER EACH LEG NOW. See full instructions below.

•

If you are installing an ECONO TRUCK RACK on the back of your truck bed, repeat the above. Before drilling the mounting plate, make

sure that the plate dose not overhang or interfere with the tail gate. Before inserting the Caps, make sure that the height setting in the rear

matches the height setting in the front.

•

If you are installing an ECONO CAB GUARD RACK, attach the CAB

GUARD to the CAB GUARD MOUNT CLIPS using bolts

flat washers

, and nuts

, as shown.

STEP 4-

Your rack can be set high or low by flipping the CROSSBAR

SUPPORT, (as shown) Determine which is best for your vehicle and your cargo.

For bowed canoes, we recommend the high position.

STEP 5-

Plug the TOP of the CROSSBAR SUPPORT UPRIGHT with caps

provided.

STEP 6- Insert the CROSSBAR into the CROSSBAR SUPPORTS

and set the entire assembly on top of the legs. Cut CROSSBAR to

shorten length, IF NEEDED, for the width of a mini-truck bed.

CENTER THE CROSSBAR LEFT TO RIGHT,

and secure with set screws. Secure the CROSSBAR SUPPORT

UPRIGHT to each leg with set screws.

Snug up against the
bed rail sheet metal

BOLT KIT FOR ONE SINGLE RACK

(2 ea.) 'T' Nuts per rack)

If there are holes in the side of the stake pockets,
position the T nut in those holes and then
attach mount plate with tap bolt.

OPTIONS:

CAB GUARD HARDWARE:

OR,

( HIGH POSITION )

( LOW POSITION )

Econo Cab Guard Rack - 30080

THAT'S IT!

You're ready to load and go!

T nut

Leg

Mount Plate

Stake Pocket

Mount Plate Clip

Crossbar Support Upright

CAB GUARD MOUNT CLIPS
(2 per leg)