JULABO SW23 Shaking Water Baths - Manual (Page 37)

Shaking Water Baths
37
12.2. List of commands
Command Parameter Response of the shaking water bath
version none Number of software version(V X.xx)
status none Status message, error message (see below)
out_mode_05 0 STOP - returns the water bath to the „OFF“ state
out_mode_05 1 START - water bath is switched to the operating state
out_mode_08 0 Circulator pump „OFF“
out_mode_08 1 Circulator pump „ON“
out_mode_09 0 Shaking operation drive motor „OFF“
out_mode_09 1 Shaking operation drive motor „ON“
out_sp_00 xxx.x Set working temperature„T“
out_sp_02 xxx.x
Set high temperature warning limit
out_sp_03 xxx.x
Set low temperature warning limit
out_sp_16 xxx.x Set shaking frequency
in_sp_00 none Ask for working temperature „T“
in_sp_02 none
Ask for high temperature warning limit
in_sp_03 none
Ask for low temperature warning limit
in_sp_16 kein Ask for shaking frequency
in_pv_00 none Ask for actual bath temperature
in_pv_01 none Ask for the heater wattage being used