JULABO HT30-M1 High Temperature Circulator - Manual (Page 63)

HT30-M1
63
in-commands: Asking for parameters or temperature values to be displayed.
Command Parameter Response of circulator
in_mode_03 none Type of the programmer input:
0 = Voltage 0 V to 10 V
1 = Current 0 mA to 20 mA
in_mode_04 none Internal/external temperature control:
0 = Temperature control in the circulator bath.
1 = Temperature control with external Pt100 sensor.
in_mode_05 none Circulator in Stop/Start condition:
0 = Stop
1 = Start
in_mode_08 none Adjusted control dynamics
0 = aperiodic
1 = standard
in_par_01 none Time constant of the external bath.
in_par_02 none Internal slope.
in_par_03 none Time constant of the internal bath.
in_par_04 none Band limiting (max. difference between the temperatures in the internal
bath and external system).
in_par_06 none Xp control parameter of the internal controller.
in_par_07 none Tn control parameter of the internal controller.
in_par_08 none Tv control parameter of the internal controller.
in_par_09 none Xp control parameter of the cascade controller.
in_par_10 none Proportional portion of the cascade controller.
in_par_11 none Tn control parameter of the cascade controller.
in_par_12 none Tv control parameter of the cascade controller.
in_par_13 none Adjusted maximum internal temperature in case of cascade control
in_par_14 none Adjusted minimum internal temperature in case of cascade control