JULABO HT30-M1 High Temperature Circulator - Manual (Page 34)

Manual operation
34
7.3. Warning functions

)) )) ))
More protection for your samples in the bath!
An audible signal sounds in intervals when the actual temperature value
exceeds one of the set limits (patented).
Overtmp:305.00°C
ExtAct: xxxxxx°C
Power: x %
Control: xxxxxx
Overtmp:240.00°C
ExtAct: xxxxxx°C
Power: x %
Control: xxxxxx
Setting the high temperature limit:
1.
Press the key .
The value previously set appeears on the DIALOG-DISPLAY (LCD)
(example: 305.00°C). A flashing segment indicates that a value
needs to be entered.
2.
Use the keypad to enter the new value
(example: 240.00 °C).
3.
Press enter to store the value.
Subtemp:220.00°C
ExtAct: xxxxxx°C
Power: x %
Control: xxxxxx
Setting the low temperature limit:
1.
Press the key .
2.
Follow the instructions
3.
for (example: 220.00 °C).
Note:
The warning functions will only be triggered when the actual bath
temperature, after start from the „OFF“ or „rOFF“ mode, lies within the set
limits for 3 seconds.