INFICON SKY CDGxxxD (RS232C) - Manual (Page 9)

tira49e1-a (2010-02) RS232C.cp
9
(completed)
Parameter name Data type Description Byte No. 2 Byte No. 3 Comment
Extended error uint8_T / Ro H-Byte 54 Bit 0 PT1000 fault 4)
H-Byte
Bit 1 Heater block overtemp. 4)
Bit 2 Electronic overtemp. 4)
Bit 3 Zero adjust error
Bit 4 Reserve
Bit 5 Reserve
Bit 6 Reserve
Bit 7 Reserve
Extended error uint8_T / Ro L-Byte 55 Bit 0 Atm. pressure out of range
L-Byte
Bit 1 Temperature out of range
Bit 2 Reserve
Bit 3 Reserve
Bit 4 Cal. mode wrong
Bit 5 Pressure underflow
Bit 6 Pressure overflow
Bit 7 Zero adjust warning
Pressure range uint8_T / Ro 56 0 F.S.R. = E-3
(Exponent)
1 F.S.R. = E-2
2 F.S.R. = E-1
3 F.S.R. = E 0
4 F.S.R. = E+1
5 F.S.R. = E+2
6 F.S.R. = E+3
7 F.S.R. = E+4
Pressure range uint8_T / Ro 57 0 Mantissa = 1.0
(Mantissa)
1 Mantissa = 1.1
2 Mantissa = 2.0
3 Mantissa = 2.5
4 Mantissa = 5.0
Gauge config uint8_T / Ro 58 0 = Analog out 0 … 10.24 V
1 = Analog out 1 … 9 V
CDG type uint8_T / Ro 59 0 = CDG025D
1 = CDG045D
2 = CDG100D
3 = CDG160D
4 = CDG200D
RW = Read / Write Ro = Read only
1) Factory setting
2) Conversion → Section 1.1, byte 6 "Read command"
3) Conversion → Section 1.1, bytes 4 and 5 "Pressure unit"
4) CDG045D, CDG100D, CDG160D, CDG200D only