INFICON Extrima Ex-certified Hydrogen Leak Detector - Manual (Page 46)

46
EN
INFICON - Operating Instructions EXTRIMA
Sira Certification Service
Rake Lane, Eccleston, Chester, CH4 9JN, England
Tel: +44 (0) 1244 670900
Fax: +44 (0) 1244 681330
Email: [email protected]
Web: www.siracertification.com
C E R T I F I C A T I O N
Project Number 25248 C Ellaby
Deputy Certification Manager
This certificate and its schedules may only be
reproduced in its entirety and without change.
Page 1 of 4
Form 9400 Issue 1
1 EC TYPE-EXAMINATION CERTIFICATE
2 Equipment intended for use in Potentially Explosive Atmospheres Directive 94/9/EC
3 Certificate Number: Sira 07ATEX2117X Issue: 5
4 Equipment: Extrima® Hydrogen Leak Detector
5 Applicant: INFICON AB
6 Address: Westmannsgatan 49
SE-582 16 Linköping
Sweden
7 This equipment and any acceptable variation thereto is specified in the schedule to this certificate and
the documents therein referred to.
8 Sira Certification Service, notified body number 0518 in accordance with Article 9 of Directive 94/9/EC
of 23 March 1994, certifies that this equipment has been found to comply with the Essential Health and
Safety Requirements relating to the design and construction of equipment intended for use in
potentially explosive atmospheres given in Annex II to the Directive.
The examination and test results are recorded in the confidential reports listed in Section 14.2.
9 Compliance with the Essential Health and Safety Requirements, with the exception of those listed in the
schedule to this certificate, has been assured by compliance with the following documents:
EN 60079-0: 2006 EN 60079-11: 2007 EN 60079-26: 2004
10 If the sign ‘X’ is placed after the certificate number, it indicates that the equipment is subject to special
conditions for safe use specified in the schedule to this certificate.
11 This EC type-examination certificate relates only to the design and construction of the specified
equipment. If applicable, further requirements of this Directive apply to the manufacture and supply of
this equipment.
12 The marking of the equipment shall include the following:
II 1G
Ex ia IIC T3 (Ta = -20°C to +50°C)