7/8 in. break-away swivel – General Machine Products 7/8" Break-Away Swivel User Manual
Page 2
![background image](/manuals/561486/2/background.png)
7/8 in. Break-Away Swivel
IMPORTANT NOTICE
Users are cautioned to ensure appropriate safeguards
exist especially during aerial cable placing. Should the
swivel break there must be sufficient support to pre-
vent the cable from reversing direction and creating
slack in an uncontrolled and potentially hazardous
manner. This is critically important when crossing
rights-of-way such as roadways, waterways or power
lines. Refer to your employer's work practices or con-
sult the factory for detailed information pertaining to
this most important safety procedure.
All personnel should stand clear of the pulling line
when using any break -away swivel, in the event that
excessive pulling resistance causes the swivel to break
apart and possibly exit the duct at great speed.
Notes:
1. Breaking tolerance ±5%
2. Warning!! Do not over tighten the tension bolt, be-
cause premature fracture may occur. Tighten the
bolt lightly until it bottoms (not using excessive
force). Then unscrew ½ turn to achieve proper bear-
ing clearance and swivel action.
3. See other side for disassembly procedure.
Aluminum 7/8 in. (22.2mm) Diameter
Break-Away Swivel
Break Point
Part Number
lbs.
kgs Color Code
Swivel
Repl Bolt
340
154
White
53700
30332
450
204 Orange
53701
34786
500
277
Violet
53706
34787
600
272 Yellow
53702
34341
800
364
Blue
53703
34342
1000 454
Green
53704
34343
1200 544
Red
53705
34344
P/N 15380 Replacement Thrust Washer Kit
General Machine Products Co., Inc.
3111 Old Lincoln Highway Trevose, PA 19053
TEL: 215-357-5500 FAX: 215-357-6216
E-Mail: [email protected]
http://www.GMPtools.com
GMP reserves the right, without notice, to make changes in equipment design
or components as progress in engineering or manufacturing methods may
warrant. All information contained herein is subject to such change.
P/N 24590 AK 060513
!
Swivel Body
Housing
(2) “O” Ring
P/N 17534
#6-32 Set Screw
P/N 17530
(2) Shoulder Screw
P/N 25300
Tension Bolt
See Chart
Thrust Washer Kit
P/N 15380
Stationary Body