Flint & Walling P07EC24 Single Tank Water Softener - Manual (Page 9)

9
INSTAllATION INSTRuCTIONS
38. Draw a 5 gallon bucket of water
to be used in the brine tank.
39. Pour the 5 gallon bucket of
water into the brine tank. See
Figure 42 for location of brine
compartment on single tank
models.
40. Measure 1-1/2 oz of chlorine
bleach and pour solution di-
rectly into the brine tank or salt
compartment on single tank
units.
41. On all tank units, pour salt into
compartment. Fill about 3/4 full
initially. Do not pack full. This is
also where iron control agents
will be put if you have rust
stains. Replace lids on the salt
compartment.
42. Adding a taste & odor filter will
eliminate chlorine and other
chemicals as well as polish-
ing the water used throughout
the entire household. Install
the whole house filter by con-
necting to the softener outlet
plumbing.
TO PROgRAM ThE
CONTROl vAlvE,
SEE SEPARATEly
ENClOSEd
INSTRuCTION
ENTITlEd “SETTINg
ThE CONTROl vAlvE.”