Flint & Walling Commander Pro 100 - Manual (Page 2)

Flint & Walling, Inc. • 95 North Oak Street • Kendallville, IN 46755 • www.flintandwalling.com
© Copyright 2008 Flint & Walling, Inc. All rights reserved.
2
1. Read these warnings and instructions carefully. Failure
to follow them could cause serious bodily injury and/or
property damage.
2. Follow all local electrical and safety codes as
well as the National Electrical Code (NEC) and the
Occupational Safety and Health Act (OSHA).
3. The power supply should be a separate circuit,
independent of all other circuits. Be sure it is equipped
with a fuse and disconnect box of ample capacity.
4. For fire protection, the power supply should be
free of any building, preferably on a direct line from the
transformer. In the event of fire, the wires will not be
destroyed and the water supply not cut-off.
5. Always disconnect power source before
performing any work on or near the motor or its
connected load. If the power disconnect point is out-of-
sight, lock it in the open position and tag it to prevent
unexpected application of power. Failure to do so could
result in fatal electrical shock.
6. DO NOT handle pump with wet hands or when
standing in water as fatal electrical shock could occur.
Disconnect main power supply before handling pump
for any reason.
7. Shut off power source when voltage drops below 210
on 230 volt installations.
8. Protect the power cable from coming in contact with
sharp objects, oil, grease, hot surfaces or chemicals.
DO NOT kink the power cable. If damaged replace
immediately.
9. NEVER leave the control box, fused disconnect switch,
or covers open (either partially or completely) when
not being worked on by a competent electrician or
repairman.
10. Always use caution when operating electrical
controls in damp areas. If possible, avoid all contact
with electrical equipment during thunderstorms or
extreme damp conditions.
11.Install all electrical equipment in protected area to
prevent mechanical damage which could produce
serious electrical shock and/or equipment failure.
12.Pump is designed to pump cold ground water that is
free of air or gases. Decreased pump performance and
life expectancy can occur if the ground water is not cold
(86ºF/30ºC) or contains air or gases.
13. Pump and controls must be securely and
adequately grounded as specified in section 250-43
item (A) of the U.S.A. National Electric Code (NEC) and
Section 26-954 Canadian Electrical Code. Failure to do
so could result in a fatal injury.
14.DO NOT use this pump to pump flammable liquids such
as gasoline, fuel oil, kerosene, etc. Failure to follow the
above warning could result in property damage and/or
personal injury.
15. The pump is intended for
use in a well. Motor frame must be connected to power
supply ground or fatal electrical shock may result. Do not
use this pump in swimming pools.
16. This product contains chemicals
known to the State of California to cause cancer and birth
defects or other reproductive harm.
NOTE: Pumps with the “CSA” mark are tested to UL
standard UL778 and certified to CSA standard C22.2 No.
108.
IMPORTANT SAFETY INSTRUCTIONS
RULES FOR SAFE INSTALLATION AND OPERATION