EUCHNER MHT-G2 - Manual (Page 8)

System Manual Mobile Hand-Held Terminal MHT-G2
8 10370-01-07/08
Structure of the menu
Menu File
Command Open
Serves for opening the previously-stored data carrier contents.
Command Save and Save as ...
Is for storing data carrier contents. The read data are stored in the form of a special
XML document. To realize this, a separate XML-tag for certain transponder data
as well as for each single byte is filled with the contents.
Command Close
Closes the application.
Menu Mode
Command ASCII and hex
Serves for changing-over between hexadecimal and ASCII notation.
Menu Block
Command New
Establishes a new storage block in the editing window. The required size of the
storage block is asked for in advance.
Command Read
Starts the read process of the data carrier.
Command Write
Writes the data shown in the editing window on the data carrier.
Command Filling character
Fills the displayed data block with a freely selectable value. The data block that has
to be written can be defined by giving a start byte and the number of bytes.
Menu Options
Submenu Language
Here, you can change the program language.
Command Configuration
Here, you can change the read/write settings and e. g. the transponder type that
shall be read-out/written on.
Command Check ports ...
Serves for functional testing of the read/write head and for support purposes.
Help menu ?
Command About
Here, information on the software version of your TCCE software is provided.