EUCHNER MHT-G2 - Manual (Page 6)

System Manual Mobile Hand-Held Terminal MHT-G2
6 10370-01-07/08
Setup
Insert the battery
Recharge the battery completely before power-on. Please see the operating in-
structions of the system manufacturer as to how to charge the battery.
Insert the SD-memory card
The Transponder Coding CE (TCCE) software for reading and writing of EUCHNER
Data carriers is delivered on a SD-memory card. As to how to insert the SD-memory
card, please see the operating instructions of the system manufacturer.
Installation of the Transponder Coding CE software
For installing the TCCE software, the memory card has to be inserted in the hand-
held terminal. By starting a special boot mode (Total Recall), the software is installed
from the SD-memory card on to the hand-held terminal.
Ensure that the write protection of the SD-memory card is not activated.
Proceed as follows:
Press the keys FN (blue) + FN (orange) + Enter/ON (red) simultaneously for
six seconds.
The boot process starts.
Wait until the operating system has run up.
Now, the icon for the software TCCE is shown on the desk top. The installation
is finished.
Attach the read head
1
2
1.

.
