EUCHNER MHT-G2 - Manual (Page 10)

System Manual Mobile Hand-Held Terminal MHT-G2
10 10370-01-07/08
Reading and writing data carriers
Reading the data carriers
Open the TCCE software.
Click on Read.
The window Read data from transponder appears.
If required, define the start byte from which shall be read and the number of
bytes to be read. If you do not change anything at this stage, the complete
memory area of the data carrier is read.
Hold the read/write head with the active face directly at the data carrier. On
CIS3, please observe orientation.
Click on OK.
The read data appear in the editing area. In each field, the content of a byte
is displayed.
Editing data
In the editing area, click on the byte that should be edited.
The cursor blinks in the selected field. Via the keys, the content is overwritten
at your mobile hand-held terminal.
Repeat step 1 for each field until all requested data are entered.
Writing the data carriers
Attention!
With overwriting, the data carrier is overwritten. The data already present might
get lost during this process.
Click on Write.
The window Write data to transponder appears.
If required, define the start byte from which shall be written and the number
of bytes to be written. If you do not change anything at this stage, the
complete memory area of the data carrier is written.
Hold the read/write head with the active face directly at the data carrier.
On CIS3, please observe orientation.
Click on OK.
The data from the editing area are written on the data carrier.
1.
.

3.
4.
5.

1.

.
1.

.
3.
4.
