Coffee brewing, Cleaning, Initial set-up (cont.) – Bunn DUAL TM (Serial # DUAL010000 - Up) 27040.0000F User Manual

Page 7

Page 7

COFFEE BREWING

1. Select the desired batch size.
2. Insert a BUNN

filter into the funnel.

3. Pour the proper amount of fresh ground coffee into the filter and level the bed of grounds by gently shaking.
4. Slide the funnel into the funnel rails.
5. Place an empty server under the funnel.
6

Place the On/Off switch in the lighted upper position. Momentarily press and release the start switch.

7. When brewing is completed, simply discard the grounds and filter.

CLEANING

1. The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all

surfaces on Bunn-O-Matic equipment.

2. Check and clean the sprayhead. The sprayhead holes must always remain open.
NOTE – In hard water areas, this may need to be done daily. It will help prevent liming problems in the brewer and
takes less than a minute.

27040 011904

INITIAL SET-UP (cont.)