ETC Source Four CE Zoom - Manual (Page 4)

2 Source Four Zoom CE User Manual
English
Source Four Zoom CE guidelines
The Source Four Zoom CE is intended for professional use only. Read the entire User Guide
before using equipment.
• Do not mount the Source Four Zoom CE on or near a flammable surface.
• Use the Source Four Zoom CE in dry locations only, where humidity does not exceed 90 percent.
• The luminaire is for indoor use only and is not intended for outdoor use.
• For temporary installations, mount and support the Source Four Zoom CE only by the primary suspension yoke
holes. Suspend the luminaire from a hook clamp or a stand mount, using a securely tightened steel bolt (up to Ø
12 mm), flat washer and locking washer.
• In addition to primary suspension, attach a safety cable (ETC part #7060A1022) or chain to the secondary sus-
pension point on the Source Four Zoom CE.
• If the external cable is damaged, it shall be replaced by ETC or our service agents.
• Always hang the Source Four Zoom CE with the colour frame held securely behind the retaining clip.
• Always replace the lamp if it becomes damaged or thermally deformed.
• Disconnect the unit from power before all cleaning and maintenance.
• The Source Four Zoom CE is suitable for indoor use with a maximum ambient temperature: T
a
=45 C
• Maximum exterior surface temperature: T
max
=217ºC
• A multilingual label sheet is included with this manual. Affix the label of the appropriate language over the existing
warning label on the extension yoke. Do not cover ETC trademark or CE mark.
• The Source Four Zoom CE contains a CE safety screen that covers the lens to prevent injury from broken glass
due to lamp failure. Do not remove the safety screen.
• Keep the luminaire at least 0.8 meters away from any lit surface. Lighted objects at this distance or greater will not
exceed 90ºC temperature from projected light.
W A R N I N G : Please note the following safety precautions.
0.8m