ETC Source Four PARNel CE - Manual (Page 7)

5
English
Colour frame holder
The colour frame holder is equipped with a spring-loaded retaining clip that prevents colour frames
and accessories from falling out. See Figure 2 .
Step 1: Release the retaining clip by pushing it sideways while gently pulling backwards.
Step 2: Insert the colour frame.
Step 3: Lock the retaining clip by pushing sideways while gently pushing forward.
Replacing the HPL lamp
A lamp must be installed before you use the luminaire.
Step 1: Disconnect power to the Source Four PARNel CE before installing the lamp.
Step 2: Loosen the knurled bolt on the back of the lamp housing, disconnect the Earth continuity
cable and pull the housing out.
W A R N I N G : Make sure all colour frame accessories are locked in position with the
retaining clip before hanging the Source Four PARNel CE.
N o t e : Use only colour frames or accessories with 19 cm mounting flange.
N o t e : Verify that the HPL lamp you intend to install is suitable for your facility’s voltage;
115-, 120-, 230-, and 240-volt HPL lamps are available.
See HPL lamp table, page 4 . Operating HPL lamps above their rated voltage
reduces lamp life and can cause premature lamp failure.
W A R N I N G : Let the lamp cool before replacing.
Figure 2
Retaining clip in the
locked position
HPL lamp
Lamp retention
brackets
Lamp housing
Figure 3
Knurled bolt
Lamp retaining clips