ElmoMC ExtrIQ Digital Servo Drives-Hawk - Manual (Page 10)

Hawk Installation Guide Safety Information
MAN-HAWIG (Ver. 1.401)
www.elmomc.com
10
1.3. Directives and Standards
The Hawk conforms to the following industry safety standards:
Safety Standard Item
Approved IEC/EN 61800-5-1, Safety Adjustable speed electrical power drive systems
Recognized UL 508C Power Conversion Equipment
In compliance with UL 840 Insulation Coordination Including Clearances and
Creepage Distances for Electrical Equipment
In compliance with UL 60950-1
(formerly UL 1950)
Safety of Information Technology Equipment
Including Electrical Business Equipment
In compliance with EN 60204-1 Low Voltage Directive 73/23/EEC
The Hawk also conforms to the following military qualitative standards:
Military Qualitative Standard Item
In compliance with MIL-STD-704 Aircraft, Electric Power Characteristics
In compliance with MIL-STD-810 Environmental Engineering Considerations and
Laboratory Tests
In compliance with MIL-STD-1275 Characteristics of 28 Volt DC Electrical Systems in
Military Vehicles
In compliance with MIL-STD-461 Requirements for the Control of Electromagnetic
Interference Characteristics of Subsystems and
Equipment
In compliance with MIL-HDBK-217 Reliability Prediction of Electronic Equipment
In compliance with ISO-9001:2008 Quality Management
The Hawk servo drive has been developed, produced, tested and documented in accordance
with the relevant standards. Elmo Motion Control is not responsible for any deviation from the
configuration and installation described in this documentation. Furthermore, Elmo is not
responsible for the performance of new measurements or ensuring that regulatory
requirements are met.