ElmoMC SimplIQ Analog Servo Amplifiers-Violin Operating Manual - Manual (Page 5)

VIO-Velocity - Operating Manual Rev 09/09. Elmo Motion Control
Page 1
Safety Information
Read this page carefully before installation and use of the instrument, and follow all instructions in
this for safe installation of this product.
INTRODUCTION
The following clauses contain information, cautions and warnings that must be followed to ensure
safe operation and to retain the instrument in a safe condition.
This product is intended for incorporation into a machine or end product. The end product must
comply with all safety aspects of the relevant requirements of the European Safety of Machinery
Directive 89/392/EEC as amended, and with those of the most recent versions of standards
EN60204-1 and EN292-2 at least.
Only qualified personnel shall carry out installation, adjustment, maintenance and repair of the
instrument.
WARNINGS
Any removal from the structure or removal of parts, except those to which access is permitted, is
likely to expose live parts and accessible terminals, which can be dangerous to life. Only a
qualified person who is aware of the hazard involved shall perform any adjustment, maintenance or
repair, of the opened instrument under voltage.
The instrument shall be disconnected from all voltage sources before it is opened (for service).
Any interruption of the protective earth conductors inside the instrument is likely to make
the instrument dangerous.
Components, which are important for the safety of the instrument, may only be renewed by
components obtained through the Elmo service organization.
Before switching on, ensure that the instrument has been installed in accordance with the
Installation Instructions.
Maximum AC & DC supplies must be according to the types described in the operating manual.
The VIO-Velocity conforms to the following industry safety standards:
Power Conversion Equipment Recognized UL508c.
Insulation Coordination Including Clearance
and Creepage Distances Of Electrical
Equipment In compliance with UL840.
Dielectric Voltage Withstand (Between the
base plate to any other part of the product). In compliance with UL1557
Conditions 12.3- 12.5, 3000VAC or
4300 VDC.
Safety of Information Technology
Equipment, Including Electrical Business
Equipment In compliance with UL1950.
Low Voltage Directive, 73/23/EEC. In compliance with EN60204-1.