Introduction, 1 harmonica connectors, Introduction -1 – ElmoMC AC Input Digital Servo Drives-Cornet User Manual
Page 4: Harmonica connectors -1
Harmonica and Bassoon Cable Kits
MAN-CBLKIT- (Ver. 3.4)
1. Introduction
This document provides the wiring details for the cables used to connect Elmo Harmonica
and Bassoon digital servo drives with the end-user application. The servo drive-side
pinouts are provided in Chapter 3 of the installation guide for each drive.
The cables come in two lengths: 2 meters (6.5 feet) or 5 meters (16.5 feet). The default
length is 2 meters. Other lengths are indicated by an extended suffix in the cable part
number. Thus, cable part number CBL-MTRENC1 indicates a 2-meter cable and cable part
number CBL-MTRENC1-
5
indicates a 5 meter cable.
CBL-RJ45CAN
2
is an exception to the part number convention described above.
For CBL-RJ45CAN
2
, the
2
suffix designates a 20 cm cable.
1.1 Harmonica Connectors
The table below presents the connector panel of the Harmonica drive and specifies the
cable connectors.
Pins Type
Connector Manufacturer
and Part Number
Port Connector
Location
8 RJ-45
RJ-45 plug
J1
8
2 mm Pitch
Molex 35507-0800
J2
12 2 mm Pitch
Molex 35507-1200
J3
2
2 mm Pitch
Molex 35507-0200
J4
8
2 mm Pitch
Molex 35507-0800
J5
4
2 mm Pitch
Molex 35507-0400
J6
3
2 mm Pitch
Molex 35507-0300
J7
7
5.08 mm Pitch
Terminal
Block
Phoenix MSTB 2.5/7-ST-5.08
J8
Table
1-1: Connectors on the Harmonica Drive
Auxiliary
Power
Supply
Digital
Output
Analog
Input
Communication
Feedback B
Feedback A
Digital
Input
J8
: Main
Power
1-1