Elkhart Brass Scorpion RF 8394-07 - Manual (Page 7)

7
Primary Panel Mount RF Controller – 81327101
The fixed RF transmitter sends signals to the monitor via an encoded
radio signal, requiring no wires between the RF transmitter and the
monitor. It is powered by the vehicle electrical system. The faceplate is
intended for a flush mount onto the pump or aerial ladder control
panel. Separate sealed push button switches are provided for up,
down, left, right, fog, and stream functions. This fixed RF transmitter
provides two-button access to the Stow feature. It will override any low-
priority controls, allowing the apparatus operator to retain ultimate
control over the monitor. Comes with 10 foot coax antenna cable and
(1) 90° antenna and (1) straight antenna.
Secondary Panel Mount RF Controller – 81327201
The fixed RF transmitter sends signals to the monitor via an encoded
radio signal, requiring no wires between the RF transmitter and the
monitor. It is powered by the vehicle electrical system. The faceplate is
intended for a flush mount onto the pump or aerial ladder control
panel. Separate sealed push button switches are provided for up,
down, left, right, fog, and stream functions. Comes with 10 foot coax
antenna cable and (1) 90° antenna and (1) straight antenna.
Caution:
Any modification of the Handheld Controller or Panel Mount enclosures will
destroy the NEMA 4 rating to that piece of equipment and will void the warranty
coverage.
MONITOR ACCESSORY
Primary OEM RF Transmitter – 81353101
The OEM RF transmitter allows the monitor installer to use their
switching arrangement while still having the benefit of the W.E.T. It has
all of the same features of the Primary Panel Mount RF controller, but
has a wiring harness for the installer to connect to the switches. Comes
with 10 foot coax antenna cable and (1) 90° antenna and (1) straight
antenna.
Secondary OEM RF Transmitter – 81353201
The OEM RF transmitter allows the monitor installer to use their
switching arrangement while still having the benefit of the W.E.T. It has
all of the same features of the Secondary Panel Mount RF controller, but
has a wiring harness for the installer to connect to the switches. Comes
with 10 foot coax antenna cable and (1) 90° antenna and (1) straight
antenna.