beautypg.com

Caution – Elkhart Brass Copperhead 8593-04 Monitor User Manual

Page 7

background image

7

MONITOR ACCESSORY
Primary OEM RF Transmitter – 81353101
The OEM RF transmitter allows the monitor installer to use their

switching arrangement while still having the benefit of the W.E.T. It has

all of the same features of the Primary Panel Mount RF controller, but

has a wiring harness for the installer to connect to the switches. Comes

with 10 foot coax antenna cable and (1) 90° antenna and (1) straight

antenna.

Secondary OEM RF Transmitter – 81353201
The OEM RF transmitter allows the monitor installer to use their

switching arrangement while still having the benefit of the W.E.T. It has

all of the same features of the Secondary Panel Mount RF controller, but

has a wiring harness for the installer to connect to the switches. Comes

with 10 foot coax antenna cable and (1) 90° antenna and (1) straight

antenna.

Secondary Switch Box Control – 81549001
This component is a surface mount type switch box with controls for

operation of the monitor for use with the OEM secondary RF transmitter.

Separate sealed toggle switches are furnished for up-down, left-right,

and strt-fog functions. The box has a NEMA 4 rating. A terminal strip

inside the enclosure allows for connection of the control cable, and a

watertight strain relief fitting provides for sealing around the cable entry

Auxilary Battery Pack – 81492001
A 12-volt, 12 amp-hr. sealed lead-acid battery pack is available to

allow operation of the monitor in case of vehicle electrical system

failure. These battery packs are also used as a means to minimize the

required size of conductors routed. This is accomplished by mounting

the battery pack near the monitor, with a small trickle-charge conductor

to the battery from the vehicle system.

Caution:

Any modification of the enclosures of any of the transmitters or switch box

will destroy the NEMA 4 rating, and will void the warranty coverage. Ensure all O-ring
and gaskets are properly installed when closing receiver or controller enclosures.