Elkhart Brass Copperhead 8593-04 Monitor - Manual (Page 6)

6
CONTROL
Handheld RF Controller
– 81282001
A sealed handheld RF transmitter contains all the controls necessary for
operation of the monitor. The handheld remote allows the operator to
direct the monitor from a significantly improved point of view. With the
wireless remote, the operator can view the stream from the side and
confirm that the stream is hitting its target. Separate push button
switches are provided for up, down, left, right, fog, and stream
functions. The handheld remote has user selectable frequency and
security codes that allow multiple monitors to operate on the same fire
ground at the same time. The remote has an automatic power down
feature that will shut down the power after 5 minutes of no activity. As
an additional power saving feature the radio signal is only transmitted
while a button is pushed. The handheld remote case has a NEMA 4
rating.
Primary Panel Mount RF Controller – 81327101
The fixed RF transmitter sends signals to the monitor via an encoded
radio signal, requiring no wires between the RF transmitter and the
monitor. It is powered by the vehicle electrical system. The faceplate is
intended for a flush mount onto the pump panel. Separate sealed push
button switches are provided for up, down, left, right, fog, and stream
functions. This fixed RF transmitter provides two-button access to the
Stow feature. It will override any low-priority controls, allowing the
apparatus operator to retain ultimate control over the monitor. Comes
with 10 foot coax antenna cable and (1) 90° antenna and (1) straight
antenna.
Secondary Panel Mount RF Controller – 81327201
The fixed RF transmitter sends signals to the monitor via an encoded
radio signal, requiring no wires between the RF transmitter and the
monitor. It is powered by the vehicle electrical system. The faceplate is
intended for a flush mount onto the pump panel. Separate sealed push
button switches are provided for up, down, left, right, fog, and stream
functions. Comes with 10 foot coax antenna cable and (1) 90° antenna
and (1) straight antenna.
Caution:
Any modification of the Handheld Controller or Panel Mount enclosures will
destroy the NEMA 4 rating to that piece of equipment and will void the warranty
coverage.