Eberspacher EasyStart Remote+ Operating instructions - Manual (Page 31)

VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn | 31
5 WhAT TO DO iF …?
iN thE EVENt Of a fault thE fOllOwiNg displays arE pOssiblE
DispLAy DesCRipTiOn ReMeDy / CusTOMeR
Pair mode
Add
ƒ Automatic detection is active.
ƒ The easystart Remote+ has been dis-
connected from the power supply and
then reconnected.
Wait until the automatic detection has
finished, then set the time and week-
day,
see page 27 and 28 .
Pair mode
AddE
ƒ battery dead. Replace battery immediately!
NO SIGNAL
ƒ no communication Check and if necessary renew the
heater fuse.
Visit your vehicle workshop.
Error
08:30
120 min
ƒ 1st heater fault. Visit your vehicle workshop.
Error
ƒ 2nd heater fault. Visit your vehicle workshop.
18:30  °C
ƒ Temperature sensor defective. Visit your vehicle workshop.