Eberspacher EasyStart Remote+ Operating instructions - Manual (Page 11)

VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn | 11
3 OpeRATiOn AnD seTTing/ADjusTMenT
hEatiNg immEdiatEly with lONgprEss (with-
Out sEttiNgs)
press the LOngpRess button for longer than
2 seconds.
Following successful data transmission – heater On.
30 min 21 °C
Display for air heaters in continuous heating mode
(factory setting).
21 °C
∞
plEasE NOtE!
After switching on, “On” is displayed for 2 sec and
then the remaining operating time or
for air
heaters.
set values are copied from the previous heating
mode.
if LOngpRess is pressed during heating mode the
display switches to the heATing submenu seT
TeMpeRATuRe seTpOinT (only for air heater) and
seT OpeRATing TiMe.
During heating mode it is possible to switch to
another menu item. under the Ventilation menu item,
check the operating time and if necessary adjust.
hEatiNg Off with lONgprEss
press the
LOngpRess button for longer than
2 seconds.
Following successful data transmission – heater OFF.
21 °C Off
The display lighting goes out 10 seconds after
heATing OFF is displayed.
plEasE NOtE!
With heATing OFF with LOngpRess all active func-
tions are ended.
The following actions are possible during the
heATing OFF display:
use the
or button to select a menu item.
shORTpRess button; the start display appears.
shORTpRess button; the heATing submenu is
displayed.