DIGIWEIGH DWP-PC - Manual (Page 16)

6.4.2 Manual Tare
2
When a container is used, follow the below steps to tare the weight of the
container off to get a net weight result.
a. Remove all loads from platter,
b. Make sure that the Zero Indicator is on. If not, press [ZERO] to set
weight reading to zero,
c. Place container on platter,
d. Press [TARE],
e. Net Indicator appears to indicate tare is in effect and weight reading
is net weight. Refer to SPECIFICATIONS for maximum tare range,
f. To cancel tare effect, remove all loads and container from platter and
press [TARE] ,
g. Net Indicator disappears. Tare effect has been removed and weight
reading is gross weight.
6.5 Price Computing
Price computing starts with determining the unit price either by keyboard
entry or recall store
6.5.1 Entering Unit Price
a. Refer to 6.2 to 6.4 for zero, selecting preferred weight unit and tare
operation,
b. Place a load on the platter. The weight of the load is displayed on the
Weight Panel
c. Enter the unit price which is displayed on the Unit Price Panel.
d. And now the Total amount is displayed on the Amount Panel.
6.5.2 Quantity Price Computing
This method is used where Total amount is calculated by quantity, not
weight
2
a. The tare operation does not permit a reduction of the value of the tare;
b. The tare effect can only be cancelled when there is no load on the platter.