DIGIWEIGH DWP-PC - Manual (Page 14)

6. INSTRUCTION FOR USE
6.1 POWER ON
Powered on the instrument, instrument displays: -
a. software and revision number and capacity of instrument,
b. calibration count value,
c. parameter set count value,
d. all LCD segments,
Then countdown process starts. After that, the instrument is ready for
operation.
6.2 START WEIGHING
a. If zero weight cannot be obtained when unloaded, press [ZERO]. After
[ZERO] is pressed, Zero Indicator appears. Refer to
SPECIFICATIONS for maximum zero range,
b. Always place an object onto platter gently. Excessive force applied to
platter may cause damages to the weight sensor inside instrument,
c. Weight of the object is displayed on thus unit automatically,
d. It is a good practice to remove all loads from platter after weighing. It
will prolong the life of the weight sensor inside instrument.
6.3 ABOUT WEIGHT UNIT CONVERSION
The instrument supports conversion among weight units. Press [UNIT] to
shift between kg, g and lb.
Enter unit price to /1LB /g /100g /kg . The Total amount will display
according to the unit
The price weight unit being employed before power off will be employed
when turned on again.
6.4 TARE OFF THE WEIGHT OF A CONTAINER
1
1
The tare weight is deducted from the weighing capacity (Max), reducing the