DIGIWEIGH DWP-11KRW - Manual (Page 10)

Floor / Pallet Scale
- 9 -
3.6 WEIGHT HOLDING FUNCTION (WHEN F3 KEY=3)
Press [MOD] key to hold the readout, press [MOD] again to release.
3.7 PRE-TARE FUNCTION (WHEN F3 KEY=4)
Press [MOD] key to enter Pre-pare Setting. Press [ZERO] to move the editable digit (blinking) and
press [TARE] to change the value. Make the displayed value equal to the container which needs to
be tare for every load. Press [FUN] to confirm. The display will show the negative number for tare
value.
3.8 ANIMAL WEIGHING (WHEN F3 KEY=5)
Press [MOD] key to set parameters of animal weighing.
1. Stable time: “Fil n” (n value can be changed). “n” value options: 1/2/3/4/5. 1 is the fastest
and 5 is the lowest. Press [TARE] to select the desired value and press [FUN] to confirm and
move to the next parameter.
2. Display Range: “Rang n”. “n” value options: 1/2/3. 2 is recommended. Press [TARE] to
select the desired value and press [FUN] to confirm and move to the next parameter.
3. Lock Range: If the change of weight exceeds the input value, the indicator will refresh the
display. Press [FUN] to confirm.
4. Press [FUN] to start animal weighing. Press [FUN] again to exit.
3.9 CHECK-WEIGHING
Check-weighing is a function to control the items to be weighed within or without the pre-set range. If
the high-limit and the low-limit are set as same value, the indicator will set alarm for one key point. If
the high-limit is set higher than the low-limit, the indicator will set alarm for a weighing range.
To set check-weighing parameters: when the indicator is off, turn it on and press [ZERO] key when
the indicator is still warming up. You will see “F1 CLK” on the screen. Press [TARE] key 3 times
and the screen will show “F4 CHK”. Press [FUN] key to enter beep mode setting:
Beep 1: No beep. When the weight is higher than the high-limit, HI will be on. When the weight is
lower than the low-limit, LO will be on. Otherwise both HI and LO will be on.
Beep 2: Beep when the weight falls into the weight range.
Beep 3: Beep when the weight falls out of the weight range.
Press [TARE] key to select desired mode then press [FUN] key to set High-limit:
Now there are 6 zeros on the screen. Press [ZERO] key to move the editable digit (blinking) and
press [TARE] to change the value. When you are done, press [FUN] to set Low-limit. When you are
done, press [FUN] to confirm. The screen will go back to “F4 CHK”
To disable the check-weighing function, press [UNIT] key to set both high-limit and low-limit to zero.
3.10 PRINTING (WHEN F3 KEY=2)
Set P 10 as “RS” (We will show to how to set P value later on.)
In the weighing mode, press [MOD] to print.