Despatch 926E Equipment Manual (C-155)Rev 2/11 - Manual (Page 48)

43
APPENDIX
IEEE 488 Interface Converter Set-up
Three DIP switches internal to the interface converter set the configuration of the
interface.
Selectable functions are read ONLY at power-on and should only be set prior to
applying power to the interface. The following lists the Despatch factory recommended
conditions.
Serial Port
IEEE
9600 Baud Mode = IEEE488 Peripheral
7 Data Bits Address = 10
1 Stop Bits Bus Terminator = LF; EOI Disabled
Odd Parity Talk-back on Terminator Enabled (SRQ)
Serial Terminator = CR Talk-back on Time Out Enabled
Echo Disabled
XON/XOFF Handshake
(Watlow device must be configured same as above.)
Note that the interface converter may be configured as an IEEE controller. In this mode
the interface converter is designed to allow an RS-232 computer to communicate with
an IEEE peripheral such as a plotter. This controller mode is described in detail in
Section 3 of the Black Box instruction manual. Note that in this mode the address
selected is that of the IEEE488 device that the converter is addressing.