Dascom 1125 User Guide - Manual (Page 38)

Tally Dascom 1125
24
Auto Tear
Manual, 0.5s, 1s, 2s, 3s, 4s, 5s
View1s, View2s, View3s
Specifies the waiting time before feeding the
page to tear-off position automatically. Manual:
Auto tear mode is off. View1s, View2s, View3s:
After printing is completed, the printer will feed
the paper until the last printed line is at the
tear-off position. (Applies to tractor mode only)
Interface Setup
Interface
Setup
Valid Settings Function
Interface
Auto, Parallel, USB,
Serial
For multi-host connection. Auto: First come first served;
Parallel/USB/Serial: Serves the designated host only.
RAM Usage User Font, Buffer
User Font: Part of RAM is used for user download characters;
Buffer: Disables user character download function; uses RAM for
expanded buffer size up to 68KB.
I-PRIME Yes, No Yes: Host I-Prime signal resets the printer.
Protocol Xon/Xoff, DTR Serial RS-232C communication protocol selection.
Data
Length
8, 7 Number of data bits per data byte selection.
Stop Bit 1, 2 Number of stop bits per data byte selection.
Parity None, Odd, Even Selects the parity check mode.
Baud Rate
9600, 19200, 38400,
300, 600, 1200, 2400,
4800
Selects the baud rate (transmission speed).
Auto IF
Delay
10s, 30s
Determines the waiting time before receiving data from another
interface.
CX Bid Yes, No
Yes: Sets the parallel interface of the printer to bidirectional
mode (IEEE 1284, Nibble mode), e.g. for Windows Plug & Play.
No: Sets the interface to compatibility mode in order to ensure
reliable operation with special external boxes.
Advanced Setup
Advanced Setup Valid Settings Function
Auto Load Manual, 0.5s, 1s, 1.5s, 2s
Specifies the waiting time before loading a cut
sheet automatically. Manual: Auto load mode is
off. (Applies to friction mode only.)
Paper Jam
Prevention
Yes, No
Flattens paper edges by carriage movement
before printing starts.
Paper End Detect Yes, No
Yes: Detects paper out and halts printing;
otherwise, ignores paper out and continues