Tally dascom 1125 – Dascom 1125 User Guide User Manual

Page 31

Tally Dascom 1125

Online State

Function Name

Switch

Operation

LED Function

Description

Tear Off

{S1}

L1, L2 flash

This is valid for tractor mode only. It feeds the form to the

tear-off position. After tearing off the form, printing starts

on the next TOF by:
 pressing S1 once, or
 receiving print data from the host.

LF {S2}

Feeds a line with every press of S2.

FF [S2]

By holding S2, the printer initially feeds a few lines; then

feeds the form to the next TOF for rear tractor or ejects

the form for cut sheets.

Load/Eject {S3}

 Load: Automatically loads the paper (according to path

selection) when no paper is on the platen.

 Eject: For rear tractor, it retracts the form from the

platen to allow users to install cut sheets. (NOTE:

Users have to toggle the path selection lever.)

For cut sheets, it ejects the form on the platen.

Setup state

[S4] > 3 secs

Toggles to Setup state. Indicated by flashing L4.

Clear Buffer

[S4]+{S1}

Clears the print buffer and beeps once when completed.

Reset

[S4]+[S1] for

longer time

Initializes the printer to the factory default settings. Beeps

3 times when completed.