Dascom 1125 User Guide - Manual (Page 34)

Tally Dascom 1125
20
Adjust Physical
Margins
[S3]+[S4]
L1, L2,
L3, L4
 Flashing of L3.
 Lights up L4.and L3.
 Lights up L1 or L2 according to current fonts.
 Includes Adjust Fanfold Top Margin, Adjust Single Top
Margin, Adjust Fanfold Left Margin, Adjust Single Left
Margin and Adjust Tear-Off position
Service Menu [S1]+[S2]
 Flashing of L3.
 Lights up L4.and L3.
 Lights up L1 or L2 according to current fonts.
 Functions are: Vertical Alignment, Change Pin, and
Endless Self-Test.
Restore Factory
Defaults
[S2]+[S3]+[S4]
L1, L2,
L3, L4
 Flashing of L3 then extinguish.
 Lights up L4.
 Lights up L1 or L2 according to current fonts.
 Restore Factory Defaults parameters except Change Pin,
Vertical Alignment and Adjust Page Margin Parameters
Menu Setup /
EDS
[S1]
Allows for Main Menu setting changes. Please read the
instructions printed on how to change settings when this
mode is activated. (EDS: Electronic DIP Switch)
Language
Setup
[S2]+[S3]
Allows user to select one of the following languages:
English, German, Russian, Italian, French, Spanish and
Turkish. Factory default is English. Refer to Language Setup
section below for details.
Language Setup
The panel menu can display the following languages: English, German, Russian, Italian, French, Spanish and
Turkish. Factory default setting is English. To change it to another language, hold down the [LF/FF] and
[Load/Eject] keys on the panel and power-on. Upon exiting the Language Setup Menu, a listing of the current
configuration is printed, and this is followed by Main Menu Setup.
Below is an example of changing from English to German language: