Dascom 7206 Cutter Installation Guide - Manual (Page 18)

– 18 –
9 Troubleshooting
If an error is detected, an alarm will sound and an LED on the control panel
will display the nature of the error.
List of error displays
CAUTION
Contact your supplier or service representative, if the following conditions
are observed.
The cutter does not cut the media well.
The blade of the cutter may be worn out or covered by a label glue.
Above error condition is occurred.
r o r r E n o i t i d n o C t n i r P r o r r E
LED LED LED
Media Out Off On On
(media location cannot be detected)
Auto Cutter Abnormality Off Off
(such as blade jamming)
Abnormal auto-cutter
temperature
Off On Off On
Off Off
Off
Off On Off Off On
On