Dascom 7206 Cutter Installation Guide - Manual (Page 11)

– 11 –
1. Function
The auto-cutter units are designed to cut various media such as labels, tickets
and tags precisely and accurately as the setting cut length.
2. Main specifications of auto-cutter
Cutting method: Guillotine cutter
Maximum cut paper thickness: 0.25 mm (0.01")
Minimum cut paper length: 25.4 mm (1")
Cut paper width: Maximum: 118 mm (4.65")
) " 1 ( m m 4 . 5 2 : m u m i n i M
Durability:
Number of cuts: Minimum 300,000 times
(for a paper thickness of 60 to 150 µm)
Minimum 100,000 times
(for a paper thickness of 150 to 250 µm)
Note Media with adhesive substance may be excluded from the number of cuts.
The number of cuts can vary according to the quality of the paper.
Media and paper types:
Roll or label (continuous, die-cut, fanfold, tag and ticket).
However, the following paper cannot be used:
Paper with thickness of 0.06mm (0.0024”) or less
Roll paper with paper core diameter of 50 mm (2") or less
Note Using paper other than the specified types may cause problems such as
paper jams, so the paper specification must be checked before use.
Cut accuracy:
Cut length tolerance: ±1.0 mm or less
Left and right cut tolerance: ±1.0 mm or less
Note Cutting position can be adjusted using printer commands (see page 12).
CAUTION
When using adhesive media, dot not
cut labels itself. Adjust the printer to
cut the liner only. If label glue sticks
to the cutter blades, irregular cutting
will occur.
Direction of paper feed