Front view3 – Dascom 7106 User Guide User Manual
Page 13
13
Setup
Part Names and Functions
= Thermal printhead
This is the printhead. Avoid touching this with your fingertips and leaving
grease or dirt on the printhead surface.
~ Platen
Interlocked with the thermal printhead, it feeds media backwards or
forwards.
! Upper sensor (!-
1
) and bottom sensor (!-
2
)
When used as a transparent sensor (for labels and tags with notches), it
is used by matching the sensor markings of the upper sensor and the
bottom sensor. When used as a reflective sensor, it is used by matching
the sensor marking on the bottom sensor with the position of the black
mark on the liner or media backing.
@ Sensor arm
The media can be installed by raising this arm.
The media can be held in place by lowering this arm.
# Media guides
(Left fixed media guide (#-
1
) and right movable media guide (#-
2
))
The end of the media is matched to the left fixed media guide, then the
right side movable media guide is moved horizontally to match it to the
media size.
$ Optional unit connector cover
It is opened when the cables of the cutter unit and the peeler unit are
connected. Do not remove during normal use.
Setting sensor positions
(p.23)
12
15
14
17
-1
16
-1
14
-2
16
-2
13